![]() Loading configuration from /etc/fancontrol. What should be the path to your fancontrol config file (/etc/fancontrol)? The fancontrol script can automatically respond to temperature changesĭo you want to set up its configuration file now (y)? Please verify that all fans have returned to their normal speed. There is either no fan connected to the output of hwmon2/pwm5, There is either no fan connected to the output of hwmon2/pwm3, The pwm outputs connected to the fan connectors,ĭid you see/hear a fan stopping during the above test (n)? Or the connected fan has no rpm-signal connected to one of There is either no fan connected to the output of hwmon2/pwm1, Would you like to generate a detailed correlation (y)? n If you do not want to do this hit control-C now!!! ![]() This may cause your processor temperature to rise!!! To run the tool, open the FanControl.exe file. Unzip the package and store all the files in a folder. Warning!!! This program will stop your fans, one at a time, 1.Download Fan Control from the official website, or its Github repository. Hwmon2/fan2_input current speed: 2621 RPM Hwmon1/fan1_input current speed: 4635 RPM Giving the fans some time to reach full speed. Hwmon2/pwm5 is currently setup for automatic speed control. ![]() Hwmon2/pwm4 is currently setup for automatic speed control. Hwmon2/pwm3 is currently setup for automatic speed control. Hwmon2/pwm2 is currently setup for automatic speed control. You want to setup this output for manual control? (n) y It is more efficient and it reacts faster. In general, automatic mode is preferred over manual mode, as Hwmon1/pwm1 is currently setup for automatic speed control. Physically verify that the fans have been to full speed However, it is ** very important ** that you The program will attempt to restore each fan to full speedĪfter testing. Fancontrol can be configured using pwmconfig. We will attempt to briefly stop each fan using the pwm controls. To make sure fancontrol is started at system startup enable the service. Note that many motherboards do not have pwmĬircuitry installed, even if your sensor chip supports pwm. This program will search your sensors for pulse width modulation (pwm)Ĭontrols, and test each one to see if it controls a fan on # Configuration file generated by pwmconfig, changes will be lost THE ETC/FANCONTROL FILE (AFTER RUNNING PWMCONFIG) Thank you so much for your help and time! Please help me identify my mistakes so that the etc/fancontrol file actually has entries. I tried getting help from Arch-Wiki but there the pwmconfig process is not further explained. I ran $ sudo sensors-detect then sudo pwmconfig (the process of pwmconfig is shown down below) and now wanted to modify the fancotrol file (also copy pasted down below) so that the fans only work at high temperatures, but unfortunatly the does not have any pairs of fans and pwms anywhere, so that it is useless.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |